SYSTEM OVERVIEW OF THE XEROX DOCUPRINT 180 LPS
1-6 XEROX DOCUPRINT 180 LPS OPERATOR GUIDE
Feeder trays
The feeder trays hold and convey paper and other materials (for
example, transparencies) used to produce printed output.
Figure 1-6. Xerox DocuPrint 180 feeder trays and inverter
feeder/stacker modules
1 Processor feeder trays
2 Inverter feeder/stacker modules
Two processor feeder trays are located in the main part of the printer.
• The main tray (tray 1) holds 1100 sheets of 20 pound/75 gsm
paper.
• The auxiliary tray (tray 2) holds 600 sheets of 20 pound/75 gsm
paper.
• If configured, trays 1 and 2 can handle paper sized from 7 by 10
inches/178 by 254 mm to 9.05 by 14.02 inches/230 by 356 mm.
There is one high-capacity feeder (HCF) tray in each of the feeder/
stacker modules (trays 3, 4, 5 and 6). The HCF trays are the primary
paper supply for the printer. If configured, each tray can handle paper
sized from 7 by 10 inches/178 by 254 mm to 14.33 by 17 inches/364
by 432 mm.
Note: In order to print on paper sized 7 by 10 inches/178 by 254
mm, you must have the 7 X 10 enablement kit. Refer to the section
“Optional printer components“ later in this chapter for more
information.
The input and output page numbers vary for each HCF tray as shown
in table 1-1.
Table 1-1. Input and output page numbers for each HCF tray
Configuration
Input
(pages)
Output
(pages)
First F/S 4000 2500
Second F/S 6500 5000
Third F/S 9000 7500
Fourth F/S 11,500 10,000
