84
a. Water inlet fault (no or insufficient water
supply)
The Water tap indicator is on or the display
alternately shows FH. Switch off the appliance
by turning the programme selector to the
position and unplug it.
Check wheter:
the water tap is completely open, and the water
supply pressure is sufficient;
the water inlet hose is kinked;
the mesh filters are blocked (see Care and
Maintenance / Water Hose Mesh Filters);
the water inlet hose is frozen.
Connect the appliance to the electrical supply.
Reselect the desired programme and press the
Start/Pause
button again to continue with the
programme (do not add detergent for this
programme)
b.Draining out fault
The display alternately shows FP. Switch off the
appliance by turning the programme selector to
the position and unplug it.
Check whether:
the drain hose is kinked (see Installation
Instructions);
the pump / filter are blocked (see Removing the
Filter / Draining Residual Water).
IMPORTANT
: before draining, allow the wash
water to cool down.
the drain hose is frozen.
Connect the appliance to the electrical supply.
Reselect the desired programme and press the
Start/Pause
button again to continue with the
programme (do not add detergent for this
programme).
If the fault re-occurs, contact After-Sales Service
(see After-Sales Service).
c. Electrical module fault
The display shows F4 to F15.
Switch off the appliance. Select a programme
and press the
Start/Pause
button once again.
The programme will continue.
If the fault re-occurs, contact After Sales Service
(See After-Sales Service).
d. Water Stop fault
(if available)
An audible tone sounds. The light of the Water
Stop indication is on.
The display shows FA and the pump is running.
Switch off the appliance by turning the
programme selector to the position, unplug
the appliance and make sure that the water tap is
closed.
The Water Stop may have been triggered
by:
1.
too much foam.
2.
a leak in the inlet hose or in the appliance.
Tilt the appliance forwards carefully to allow the
collected water to flow out.
Then:
1.
connect the appliance to the electrical supply,
2.
open water supply to machine (if
Start/Pause
button is not pressed, but machine begins to fill,
close water supply and call After-Sales Service),
3.
reselect the desired programme and press the
Start/Pause
button (there is no need to add
additional detergent). The programme will
continue.
If the faults occurs again, call After-Sales Service
with details about the fault (see After-Sales
Service).
