Whirlpool Markası'nın Ürünleri

Delayed start

It is possible to delay the start time of the wash cycle by 3,

6 or 9 hours:

1:After selecting the desired wash cycle and any other

options, press the DELAYED START button. the indicator

light will go on.

2:Selectthe desireddelaytime bypressingthe Delayed

Start button repeatedly. The wash phase (3 hours), drying

phase(6hours)andend(9hours)indicatorlightswillgoon

in succession.

If the Delayed Start button is pressed again, the option is

deselected and the indicator light goes off.

3. After the selection process, the countdown will begin if

theStart/Pausebuttonispressed.Theselecteddelay-period

indicator light flashes and the Start/Pause button stops

flashing (fixed light).

3.Oncethistimehaselapsed,theDELAYEDSTARTindicator

light goes off and the wash cycle begins.

The Delayed Start function cannot be set once a wash

cycle has started.

Notes:

Optimumperformancelevelswhenusingthe“Sixty"and"Rapid

40’”cyclescanbeachievedbyrespectingthespecifiednumber

of place settings.

To reduce consumption even further, only run the dishwasher

when it is full.

Note for Test Laboratories:

forinformationoncomparativeEN

testing conditions, please send an email to the following address:

[email protected]

Half load

If there are not many dishes to be washed, a half load cycle

may be used in order to save water, electricity and detergent.

Select the wash cycle and press the HALF LOAD button; the

indicator light will go on.

Press the HALF LOAD button again to deselect this option.

Remember to halve the amount of detergent.

Wash options*

The OPTIONS may only be set, changed or reset after

the wash cycle has been selected and before the Start/

Pause button has been pressed.

Only the options which are compatible with the type of wash

cycle set may be selected. If an option is not compatible

with the selected wash cycle

(see Table of wash cycles)

, the

correspondingsymbol/LEDflashesrapidly3times.

If an option is selected which is not compatible with another

previously-selected option, it will flash 3 times and go off,

while the most recently selected option will remain active.

To deselect an option which has been set by mistake, press

the corresponding button again.

Special wash cycles

and Options

* Only available in selected models.