9
Daily check
Filling the salt reservoir
Dissolve limescale (not necessary if water hardness
level is set to “soft 1”!)
Visual indicator (depending on the model).
Unscrew cap.
Fill the salt reservoir with water before the first wash
only.
Add salt (never add detergent!) min. 0.8 kg / max. 1kg.
Screw on the cap. Salt residual around the cap need to
be removed. Some salt reservoir have a level indicator
integrated in the cap (see to the right how to check).
Once regeneration salt is added, immediately
start a wash program (the “Pre-wash” program
alone is not sufficient).
Residual saline solution or grains of salt can
lead to deep-down corrosion, irreparably
damaging the stainless steel components.
The guarantee is not applicable if faults are
caused by such circumstances.
The salt level indicator lamp may remain lit at
the end of several wash cycles. If the water
hardness is set to level 1 (soft), no salt is
required and salt indicator lamp will remain off.
(depending on the model)
Salt indicator on the control panel
The indicator lamp lights up when SALT
NEEDS TO BE ADDED.
Salt indicator on the salt reservoir cap
green: OK.
clear: NEEDS TO BE ADDED
Before first use, run the appliance with detergent
and without loading.
