Dil ID: 6
Dil Adı: turkish
Dil Kodu: tr1tayfun Whirlpool Markası'nın Ürünleri
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



22
In order to avoid that there is m ore w ater staying in the i nlet hose,
please close the hydrant after using.(For the models : no safety inlet hose.)
Positioning the Appliance
How to Drain Excess Water From Hoses
If the s ink is 100 0 hi gher fr om the floor, the exces s wa ter i n h oses cannot be dr ai ned di rectly
into the sink. It will b e necessa ry to d rain excess water from hoses into a bowl or suitable
conta iner th at is hel d ou tside and lower t han the sink.
Water Outlet
Connect the water drain hose. The drain hose must be correctlyfitted to avoid water leaks.
En sure tha t th e wat er i nl et h ose i s n ot ki nked or s quashed .
The following things should be checked before starting the dishwasher.
Syphon Connection
Th e wa ste c onnecti on m us t be a t a h eigh t of betw een 50 c m ( min imum) a nd 10 0 cm (m aximum )
fromthe bottom of the dish. The water drain hose should be fixed by a hose clip.
Start of Dishwasher
The content of this manual is very helpful to the users.
After installation, please make sure to keep this manual.
Extension Hose
If y ou n eed a dr ain h ose ext ension, m ake sur e t o use a simi la r dra in ho se.
It m ust be n o lon ger than 4 m et res; o ther wise the clea nin g e ffect o f t he dis hwashe r cou ld b e re duc ed.
1 The dishwasher is level and fixed properly
2 The inlet valve is open
3 There is a leakage at the connections of the conducts
4 The wires are tightly connected
5 The power is switched on
6 The inlet and drain hoses are knotted
7 All packing materials and printings should be taken out from the dishwasher
Connect the cold w ater s upply h ose to a thre aded 3/4(inch) connector a nd make s ure
tha t i t is fas tened tightly in place .
If the water pipes are new or have not been used for an extended period of time, le t the
water run to mak e sure that the water is clear. This p recaution is needed to avoid the
risk of the water inlet to be blocked and damage the appliance.
The water su pply to the appliance can also be connected to the household hot water
line (such as, central system, heating system),as long as it does not exceed a
temperature of 60 C. In this case, the wash cycle time will be shortened by about 15
minutes and the wash e fficiency slightly reduced.
The connection must be made to the hot water line following the same procedures as
described in the section for the con nection to the col dwat er line.
Positi on the app li ance i n the desired loca tion. T he bac k should rest ag ain st the wall behind i t, an d the si des,
along the adj acent c abi nets o r wa lls. The dish wa sher i s eq uipp ed with wate r suppl y and drai n h oses that can
be positio ned either to the right or the left sides to facilitate proper i nstallation.