Programming the Universal Remote Control
The TV component button has been preset to work with your Micro Chip Display
Projection TV (program code 0080). You can program the remote control to work with
as many as seven other components.
To program the remote to control other components:
1 Turn on the component.
2 Press the matching component button on the remote control.
3 Press and hold the SETUP button until the LED flashes twice.
4 Enter the programming code for the component and manufacturer. For a list of
component programming codes, see “Component Program Codes” on page 13.
If the code is accepted, the LED flashes twice after the last digit is entered.
If the LED does not flash twice, repeat Steps 2 through 4 with the next code listed for
the component and manufacturer.
Important
If there is more than one code listed for the component and
manufacturer, make sure that you try all the codes listed to find the
one that works for the component.
5 Point the remote control at the component and press the POWER
button. The component should turn off.
Tips & Tricks
If you cannot find your manufacturer in the component list or the
program code does not work, you can use the remote control to
search for the correct component code. See “Searching for
Component Codes” on page 24.
