DISASSEMBLY
A. DOOR
1. Loosen 3 screws holding an upper hinge to separate the
door body. (Figure 7)
C. COMPRESSOR AND PTC
B. THERMOSTAT
1. Pull Knob Dial.
2. Loosen 1 screw holding the case and pul! it out to
remove the Thermo cover. (Figure 8)
Remove Clamp, Protector Cover, Power Cord and Lead
Wire first. (Figure 10)
Separate OLP.
Separate PTC.
Remove the Compressor Base by loosening 4 bolts fixed
to base plate of the set. (Figure 11)
5. Remove the Compressor by loosening 2 earth screws
next to Compressor.
NOTE : Replace the Compressor, after peeling off
painted part of earth terminal.
• Compressor inhaies the gas evaporated from Evaporator
and condenses this gas and then delivers to Condenser.
• PTC is abbreviation of Positive Temperature Coefficient
and is attatched to the Compressor, and operates motor.
• OLP prevents Motor coil from being started inside
Compressor.
• Do not turn the Adjust Screw of OLP in any way for
normal operation of OLP.
3. Pull out thermostat in the theremostat cover, and
disconnect lead wires. (Figure 9)
NOTE ; Replace a new thermostat with proper specification.
-8-
