Filename:AMPIC5_6 MANUAL
07/18/08
Page 4 of 16
Installation Instructions
Model AMPIC5 / AMPIC6
(UL Listed)
AMPIC5 / AMPIC6 carton includes the following items:
1. One (1) each AMPIC5 or AMPIC6
2. One (1) each UL Listed Power Supply
( IC5/IC6, Tile Bridge, Backcan and Volume Controls are Optional – Sold Separately)
Introduction:
The AMPIC5/AMPIC6 is designed to provide an OWI 5.25” (IC5) or 6.5” (IC6) speaker that is self powered
allowing line input audio that is either balanced or unbalanced to provide the input signal. The power amplifier
provides up to 25 watts of power. It has enough power to allow up to a total of four non-amplified speakers to
be powered by one power amplifier installed on one of the four non-amplified speakers. This would then allow
each speaker to have approximately 5 watts of power. Five watts would be enough power for background
music, voice paging or many voice applications. The AMPIC5/AMPIC6 can also be daisy chained up to a
maximum of 20 connected amplified speakers.
Specifications:
Model Number
AMPIC5 / AMPIC6
Frequency Response 50 Hz to 15 kHz. HF is optimized to enhance frequency
response of the speaker.
THD <.1%
S/N >90dB
Input Configuration Differential (noise reducing)
Minimum Common Mode Rejection 40dB
Maximum Power Output 25 Watts
At load impedance 4 Ohms (2 speakers in parallel or 4 speakers in series parallel)
Minimum Power Supply Voltage 8 Volts
Maximum Supply Voltage 14 Volts
Maximum current protected Yes
Short Circuit protected Yes
One wire to ground protected Yes
Minimum Load Impedance 3.2 Ohms
Input Load Impedance 10K Ohms
Plastic Fire rated V-0
Maximum number of Amplifiers on one line 20
Available Backcan (Sold Separately) UL Listed and Plenum rated
Available Tile Bridge (Sold Separately) Support Truss
Warranty 1 year
