System Upgrade 8-49
N8803-031F Fibre Channel Controller
Slots to install the board
PCI slot
Group 1 Group 2
N code Name
#1 #2 #3 #1 #2 #3
Remarks
N8803-031F
Fibre Channel
Controller
–
√ √
–
√ √
Each PCI module can
contain one board only.
Only one of them can be
mounted. (cannot be
mounted together)
√: Can be installed. –: Cannot be installed.
Installation of driver
When you start the system with the N8803-031F Fibre Channel Controller installed, it
automatically becomes available.
IMPORTANT:
Insert the N8803-031F after the installation of OS is completed. Use the
N8803-031F in pairs. Insert one into a slot in a PCI module and the other one into
the slot at the same location in the other PCI module.
After starting the system with the N8803-031F installed, make settings of the SCSI
topology.
PCI Board Status LED Indications
LED indications
Fail LED State LED
Description Action
Off Amber
The Fibre Channel disk
array device is not
connected yet, or not
connected correctly (not
duplicated)
Check the connection to the
Fibre Channel disk array
device. (For details, see the
instruction manual of the Fibre
Channel disk array device.)
Off Green
The PCI board is
operating normally in
duplex mode.
-
Off Off
The PCI board is not
installed yet, the PCI
board is installed
incorrectly, or the power is
not supplied.
Mount the PCI board correctly.
If the PCI board was not
mounted, there is no problem.
Check the condition of power
unit.
Remount the PCI module.
Red Amber
The PCI board is on a
software control test, or is
preparing for the
operation.
Wait for a while until the
indication changes. If the
indication does not change,
check the status of the
installed PCI board slot using
NEC ESMPRO Manager.
Red Off
Although the PCI board is
mounted, it may be offline
or not be working.
Make the installed PCI board
slot online from NEC
ESMPRO Manager.
Mount the PCI board correctly.
