
23OPERATION
ENGLISH
Time and Status Display
1
2
3 4 5
Cycle Status Indicator
These LEDs will illuminate when a cycle is
selected to indicate which stages will run. When
a cycle is running, the LED for the active stage
will blink, and the LEDs for the remaining stages
will remain steady. Once a stage is complete, the
LED will turn off. If a cycle is paused, the active
stage LED will stop blinking.
Estimated Time Remaining
When a cycle is selected, the default time for
that cycle is displayed. This time will change
as modiers or options are selected. Once the
Start/Pause button is pressed, the washer will
measure the size of the load. The estimated
time may change once the load size has been
measured. If Delay Wash is set, the remaining
delay time counts down until the cycle begins.
NOTE
• The time shown is only an estimate. This time is
based on normal operating conditions. Several
external factors (load size, room temperature,
incoming water temperature,etc.) can affect the
actual time.
Door Lock Indicator
The Door Lock indicator lights up once a cycle
has started. The indicator light stays on until the
cycle is paused, stopped or has nished.
Control Lock Indicator
When the Control Lock function is activated, a
message and the remaining wash time are
displayed, in turn, on the display panel of the
washer. When the Control Lock function is set,
all controls are disabled except for the Power
button.
1
2
3
4
Add Garment Indicator
Laundry may only be added to the load at the
proper time in the wash cycle. When the Add
Garment light is illuminated, it is safe to pause
the cycle and add more items to the load. If
garments are added when the Add Garment light
is off, the washer will not adjust for these items
which could result in poor performance and/or
fabric damage.
1. Press the Start/Pause button to pause the
washer.
2. Open the lid (door) after it unlocks.
3. Add your additional items.
4. Close the lid (door).
5. Press the Start/Pause button. The cycle will
resume after the lid (door) locks.
5