17
Washing Programs
Close the lid Finish Caution & Note
The pulsator rotates for 8
seconds to detect the
laundry load.
Then the WATER LEVEL and
the amount of Detergent to
be used will be shown and
water will be supplied.
Water will be
supplied for 2
minutes after the
start of the wash to
supplement the
water the laundry
has absorbed.
When the wash
program ends, the
buzzer will ring for
10 seconds before
the Power goes off
automatically.
If water is already in the tub, or putting
wet laundry into the tub before starting
will increase the WATER LEVEL.
With lightweight bulky loads, WATER
LEVEL can be set low.
Changes to Water Temperature
(HOT/COLD) and wash level are
possible during operation.
(refer to page 14)
When setting the WATER LEVEL manually,
do not set to Medium to prevent damage to
laundry.
Washing with HOT water may damage the
laundry (Water is set to cold automatically).
Ensure that the load is under 2kg.
In order to avoid damage to laundry,
the spin cycle may appear slow.
This also avoids wrinkles and clothing may
still contain some water. This is normal.
Before starting to wash, make sure that the
laundry is washable.
Washing with HOT water may damage the
laundry (Water is set to COLD
automatically).
Ensure that the load is under 2kg.
