7
nstallation
I
▶
Water supply pressure must be between 30kPa and
1000kPa (0.3~10kgf/cm
2
)
▶
Don’t strip or crossthread when connecting Inlet
hose to the valve.
▶
If the water supply pressure is more than 1000kPa,
a decompression device should be installed.
• Two rubber seals are supplied with the water
inlet hoses these are in order to prevent water
leaks.
• Check water tightness of washing machine
connections by turning the tap completely on.
• Periodically check the condition of the hose and
replace the hose if necessary.
• Make sure that there is no kink on the hose and
that it is not crushed.
▶
When your washer has two valves,
• The Inlet hose which has red connector is for the
hot water tap.
• If the washer has two valves, the energy is
saved by using hot valve.
Washing Machine is to be connected to the water mains using new hose-
sets and that old hose-sets should not be used.
Connecting water supply hose
1. Do not use an extension cord or double adapter.
2. If the supply cord is damaged, it must be replaced by the manufacturer or its service agents
or similarly qualified person in order to avoid a hazard.
3. Always unplug the machine and turn off the water supply after use.
4. Connect the machine to an earthed socket in accordance with current wiring regulations.
5. The appliance must be positioned so that the plug is easily accessible.
• Repairs to the washing machine must only be carried out qualified personnel. Repairs carried
out by inexperienced persons may cause injury or serious malfunctioning. Contact your local
service center
• Do not install your washing machine in rooms where temperatures below freezing may occur.
Frozen hoses may burst under pressure. The reliability of the electronic control unit may be
impaired at temperatures below freezing point.
• If the appliance is delivered in the winter months and temperatures are below freezing : Store
the washing machine at room temperature for a few hours before putting it into operation.
Electrical connection
