3 pin
Min. 60 cm (23.6”)
Min. 90 cm (35.4”)
The drain hose may be extended to a
maximum of 4 metres. An additional drain
hose and joining piece is available from your
local Service Force Centre. The joining piece
must have an internal diameter of 18 mm.
If your drain hose looks like this (see below)
you do not require the “U” piece”. Just push
the hose firmly in to the standpipe.
2. Onto a sink outlet spigot.
If the outlet spigot has not been used
before, remove any blanking plug that may
be in place.
Push the drain hose onto the spigot and
secure with a clip, ensure a loop is formed in
the drain hose (see diagram) to prevent
waste from the sink entering the appliance.
If you intend to drain the hose from the
machine into a sink, make sure that the sink
is empty and the plug hole is not blocked.
Use the plastic “U - Piece” supplied.
Important! Before connecting up the
machine to new pipework or to pipework
that has not been used for some time, run
off a reasonable amount of water to flush
out any debris that may have collected in the
pipes.
33
