Problem Possible
cause
Solution
The tem-
perature of
the shaver
is too high.
In this case,
the shaver
does not
work.
Let the
shaver cool
down. As
soon as the
temperature
of the shaver
has dropped
sufciently,
you can
switch on the
shaver again.
The shaver
does not
work, even
though it is
connected
to the
mains.
This shaver
is not
designed
to be used
directly
from the
mains.
Remove
the adapter
from the
wall socket
and the small
plug from
the shaver.
You can now
switch on the
shaver again.
My skin is
irritated
after shav-
ing.
Your skin
needs time
to get
used to
the Philips
shaving
system.
Skin irritation
during the
rst 2-3
weeks of use
is possible.
After this
period, the
skin irritation
usually disap-
pears.
The shaving
heads are
damaged
or worn.
Replace the
shaving heads
(see chapter
‘Replace-
ment’).
The rota-
tion speed
of the
shaving
heads is
lower than
usual.
Too much
dirt has
collected in
the shaving
heads.
Clean the
shaving heads.
See chapter
‘Cleaning and
maintenance’.
The re-
chargeable
battery is
low.
Recharge
the battery.
See chapter
‘Charging’.
Recycling
- Do not throw away the appliance
with the normal household waste at
the end of its life, but hand it in at an
ofcial collection point for recycling.
By doing this, you help to preserve the
environment (Fig. 26).
- The built-in rechargeable shaver battery
contains substances that may pollute
the environment. Always remove the
battery before you discard or hand in
the shaver at an ofcial collection point.
Dispose of the battery at an ofcial
collection point for batteries. If you
have trouble removing the battery, you
can also take the appliance to a Philips
service centre. The staff of this centre
will remove the battery for you and will
dispose of it in an environmentally safe
way (Fig. 27).
Removing the rechargeable
shaver battery
Only remove the rechargeable battery
when you discard the shaver. Make sure
the rechargeable battery is completely
empty when you remove it.
Be careful, the battery strips are sharp.
1 Undo the screw in the back panel
of the shaver with a screwdriver
(1) and remove the back panel
(2) (Fig. 28).
2 Bend the hooks aside and remove the
power unit (Fig. 29).
3 Break the snap hooks (1) and remove
the front panel of the power unit
(2) (Fig. 30).
4 Take out the battery holder (1) and
cut the battery tags with a pair of
cutting pliers (2) (Fig. 31).
5 Remove the rechargeable battery.
Guarantee and support
If you need information or support, please
visit www.philips.com/support or read
the separate worldwide guarantee leaet.
Guarantee restrictions
The shaving heads (cutters and guards)
are not covered by the terms of the
international guarantee because they are
subject to wear.
Troubleshooting
This chapter summarises the most common
problems you could encounter with the
appliance. If you are unable to solve the
problem with the information below, visit
www.philips.com/support for a list of
frequently asked questions or contact the
Consumer Care Centre in your country.
Problem Possible
cause
Solution
The shaver
does not
shave as
well as it
used to.
The shaving
heads are
damaged
or worn.
Replace the
shaving heads
(see chapter
‘Replace-
ment’).
The shaving
heads are
dirty.
Clean the
cutters and
guards with
the clean-
ing brush
supplied
(see chapter
‘Cleaning and
maintenance’,
section
‘Extra-thor-
ough cleaning
method’).
Long hairs
obstruct
the shaving
heads.
Clean the
cutters and
guards with
the clean-
ing brush
supplied
(see chapter
‘Cleaning and
maintenance’,
section
‘Extra-thor-
ough cleaning
method’).
The shaver
does not
work
when I
press the
on/off
button.
The re-
chargeable
battery is
empty.
Recharge
the battery
(see chapter
‘Charging’).
- 本產品不適合供下列人士 (包括小
孩) 使用：身體官能或心智能力退
化者，或是經驗與使用知識缺乏
者。他們需要有負責其安全的人員
在旁監督，或指示產品的使用方
法，方可使用。
- 請勿讓孩童使用本產品或將本產品
當成玩具。
- 在水龍頭下沖洗本產品之前，
請先拔掉產品電源插頭。
警告
- 切勿使用超過 80°C 的熱水沖洗
產品。
- 如有損壞情況，請勿繼續使用該產
品、轉換器或任何其他零件，否則
可能導致受傷。轉換器或零件如有
受損，請務必以原型號更換之。
- 絕對不可使用壓縮空氣、鋼絲絨、
磨蝕性的清潔劑或侵蝕性的液體
(例如汽油或丙酮) 清潔本產品。
- 在您沖洗時，水可能會從電鬍刀底
部的插孔流出。此為正常現象，
不會造成危險，因為所有的電子
零件都密封於電鬍刀內的電源裝
置中。
符合標準
- 這款防水電鬍刀符合國際公認的安
全規範。適合在泡澡或淋浴時使
用，且可在水龍頭底下清潔。基於
安全考量，本電鬍刀只能以無線方
式操作。 (圖 2)
- 本飛利浦產品符合所有電磁波暴露
的相關適用標準和法規。
一般
- 本轉換器配備有自動電壓選擇器，
適用 100 到 240 伏特的插座電壓。
- 轉換器可將 100-240 伏特的電壓轉
換為低於 24 伏特的安全低電壓。
一般說明 (圖 3)
1 保護蓋
2 附電鬍刀刀頭固定座的電鬍刀組
3 電鬍刀刀頭固定座釋放鈕
4 開關按鈕
5 「電量不足」指示燈
6 固定環
7 刀具
8 刀網
9 電鬍刀刀頭固定座
10 鬢角刀 (限特定機型)
11 轉換器
12 小插頭
13 清潔刷
Problem Possible
cause
Solution
The
shaving
heads do
not stay in
place.
You did not
x the re-
taining rings
properly.
The retaining
ring is xed
properly
if the two
wings of the
retaining ring
are located
exactly under
the projec-
tions of the
shaving head
holder.
After fully
charging
the shaver,
it provides
less than
30 shaving
minutes.
If you have
a heavy
beard, the
shaver may
provide
less than
30 shaving
minutes.
The num-
ber of shav-
ing minutes
may also
vary over
time,
depending
on your
shaving
behaviour,
cleaning
habits and
beard type.
繁體中文
簡介
恭喜您購買本產品並歡迎加入飛利浦！
請於 www.philips.com/welcome 註冊您
的產品，以善用飛利浦提供的支援。
重要事項
在使用本產品前，請先仔細閱讀本使用
手冊，並保留使用手冊以供日後參考。
危險
- 請保持轉換器乾燥。 (圖 1)
警示
- 轉換器內含一個變壓器。請勿切斷
轉換器而以其他插頭取代，否則會
造成危險。
