1
2
3
1. Turn the top of the Action Clean unit counter-
clockwise and pull top from Cleaning
Chamber. (Fig. 1)
2. Remove the filter unit from the Cleaning
Chamber. (Fig. 2)
3. Depending on your razor model, select either
the two or three head holder. Place it on top
of filter unit, ensuring that the three notches
of the holder fit in the slots of the filter unit.
Replace the filter unit into the Action Cleaning
Chamber, making sure that the filter unit clicks
down into place. (Fig. 3)
How to use your
Action Clean
Razor Head
Cleaner
8. When finished, remove top from Action
Cleaning Chamber and remove Razor Head
Assembly. (Fig. 8) Place Razor Head
Assembly on a paper towel to air dry. Make
sure Razor Head Assembly is completely dry
before placing it back on your razor.
9. DO NOT RINSE WITH WATER.
10. After each cleaning, spread one drop of
lubricating oil from the tube included,
Norelco Razor Lubricant Model AL80, or
one drop of mineral oil over each razor
head using your finger.
11. For consistently close and comfortable
shaves, you should clean your razor heads
every 4 - 6 weeks or when the display on
your razor tells you to do so. If your shave
is still not close enough, you may need new
replacement heads.
12. Change the filter and Action Clean Cleaning
Solution at least once a year. (Fig. 9,10,11)
13. Use only Norelco Action Clean Cleaning
Solution with filter, model HQ101, with this
unit.
9
6
7
8
4. Empty the contents of the Action Cleaning
Solution into the Cleaning Chamber. (Fig. 4)
5. Place Razor Head Assembly from razor (with
heads in place) onto Head Holder. (Fig.5)
6. Replace top on Cleaning Chamber, making
sure that it locks into place by turning clock-
wise until it “clicks” into place. (Fig. 6)
7. Clean heads by pumping the top on the Action
Cleaning Chamber for about 30 seconds.
(Fig.7)
10
11
5
4
