load originals and load paper
12
hp psc 2200 series
set the paper type
If you want to use a different type of paper, such as photo paper,
transparency film, Iron-On T-shirt transfers, or brochures, simply load that
paper in the paper tray. You must then change the paper type settings to
ensure the best print quality.
HP recommends paper type settings according to the type of paper you’re
using.
Labels
(works only with
printing)
• Always use letter-size or A4-size label sheets designed for use with
HP inkjet products (like Avery Inkjet Labels), and make sure that the
labels are not over two years old.
• Fan the stack of labels to make sure none of the pages are sticking
together.
• Place a stack of label sheets on top of standard paper in the paper
tray, print-side down. Do not insert labels one sheet at a time.
Postcards or hagaki
cards (only works
with printing)
Insert a stack of postcards or hagaki cards with the print-side down into
the paper tray until it stops. Line the postcards up on the right side of the
paper tray, slide the width guide up against the left side of the cards, and
then slide the paper-length guide in until it stops.
Continuous (banner)
paper
(works only with
printing)
Continuous banner paper is also known as computer or z-fold paper.
• Before loading banner paper, remove all other paper from the paper
tray, then remove the output tray.
• If you use non-HP banner paper, use 20-lb. paper and fan the paper
before loading it.
• Verify that the stack of banner paper contains at least five pages in the
stack.
• Carefully tear off the perforated edge strips from both sides of the
paper stack, if any, and unfold and refold the paper to make sure the
pages do not stick together.
• Put the paper in the paper tray so that the unattached edge is at the
top of the stack. Insert the first edge into the paper tray until it stops, as
shown in the illustration above.
• Replace the output tray.
paper tips
Remove the output
tray.
Insert the unattached
edge of the paper into
the paper tray.
