23
ge.com
Non-coin-op commercial washers and dryers
GE washer
WNRD2050D
Capacity
Capacity (cu. ft.) 3.5 stainless steel
Features
Motor 2-speed
Wash/spin speed
combinations
3
Wash/rinse temperatures 3
Water levels 4
Digital cycle countdown
●
Number of wash cycles 5
White cottons
●
Colored cottons
●
Bright colors
●
Permanent Press
●
Delicate
●
Spin only
●
Bleach dispenser
●
Fabric softener dispenser
●
Quiet performance Deluxe quiet
Lid instructions
●
LED indicators
●
Appearance
Colors available White
Weights & Dimensions
Approx. shipping wt. (lbs.) 160
GE dryer
DNCD450EA/GA
Capacity
Capacity (cu. ft.) Super (7.0)
Features
Dry cycles 5
Cottons/high heat
●
Mixed loads/high heat
●
Perm. press/medium heat
●
Knits/low heat
●
Delicates/extra low heat
●
Temperatures 4
Air dry
●
Digital cycle countdown
●
Quiet performance Hush quiet
Lockable lint filter
●
LED indicators
●
Door swing Reversible
Drum material White DuraDrum
Appearance
Colors available White
Weights & Dimensions
Approx. shipping wt. (lbs.) 125
Exhaust options:
Electric: 4-way venting: left, right, bottom and rear. Maximum recommended exhaust
duct length is 45 feet of 4" rigid ducting with two 90° elbows and 4" dampered wall cap.
Gas: 3-way venting: left, bottom and rear. Maximum recommended exhaust duct length
is 15 feet of 4" rigid ducting with two 90° elbows and a dampered wall cap. Dryer is
shipped with exhaust to the rear. (See Installation Instructions.)
See Pub. No. 31-1746 for installation instructions.
See Pub. No. 31-15400 for installation instructions.
Note: Coin slide or coin drop, coin vault, and locks for cover and meter case access
door are not provided with washer.
Energy saving:
All wash cycles include energy-saving cold water rinse. Total cycle time—24 minutes plus
fill time. Actual wash time is 8 minutes with a final spin speed of approximately 630 RPM.
Circuit requirement:
An individual, properly grounded
15- or 20-amp branch circuit is required.
Electrical rating:
115V, 60Hz
Circuit requirements:
Electric An individual branch circuit fused
for 30 amps is required for each dryer.
Electric dryer rating:
240V, 60Hz, 5600W, 24A
208V, 60Hz, 4400W, 22A
Gas: An individual branch circuit fused for
15 or 20 amps is required for each dryer.
Gas dryer rating: 120V, 60Hz
Gas (BTU/Hr): 20,000. Factory equipped
for natural gas. Tested for LP gas. A
conversion kit is required for LP gas. Check
installation instructions for correct kit
number. Have a qualified technician install
the conversion kit. Equipped with energy
saving Glo-Bar ignition.
Dryer note: Dryer wall outlet must be
located within 36" of service cord entry
and accessible when dryer is mounted
in position.
Note: Dimensions and specifications
shown here are correct at the time this
sheet was printed. Before proceeding
with construction or rough-in, check
installation instructions that came with
your unit. Specifications, dimensions and
design are subject to change without notice.
39864_harmony2_con_merch.indd 2339864_harmony2_con_merch.indd 23 1/25/05 3:26:42 PM1/25/05 3:26:42 PM
