2.
Turn the cycle control knob clockwise to
point to the desired cycle. See page 7 for
cycle descriptions.
You will feel a definite stop at each cycle
mark. The dishwasher will automatically
start the cycle you selected.
NOTE:
If the door is latched, you will hear
cycles start and stop as the knob passes
each cycle mark. This is normal and will
not hurt the dishwasher. If you prefer, you
can set cycles with the door unlatched.
Adding a dish during a cycle
You can add an additional item to the
dishwasher anytime before the knob
reaches Light Wash. See page 7.
1.
Lift up on the door latch to unlatch the
door and stop the cycle. Wait a moment
for the spray action to stop before open-
ing the door.
2. Open the door and add the dish.
3. Close the door. Do not latch it. Wait 30
seconds for air in the dishwasher to warm
up. This helps reduce the amount of
moisture that can come from the vent
when restarting the cycle.
4. Press door in to latch it. The dishwasher
will start where it stopped.
Changing a cycle setting
You can change a setting anytime during
any cycle.
1.
2.
3.
Lift up on the door latch to unlatch the
door and stop the cycle.
Turn the cycle control knob clockwise to
the cycle you want.
Check the detergent dispenser to be sure
it is properly filled for the new cycle. See
pages 8-9.
NOTE:
Turning the cycle control knob
may cause the covered section of the
detergent dispenser to open. Be sure to
fill the covered section, and close the
cover, if the cycle uses detergent in both
sections.
4. Close and latch the door. The dishwasher
will automatically start the new cycle.
Changing the Dry Select option
Youcanchange
anytime during a
To change the
drying option.
the Dry
cycle.
option,
Select option
select the other
6
