
26
Slit for mounting
the clamp
Mounting clamp
White plastic cap
6. The rst and second clamps must be positioned and
secured diagonally prior to mounting the rest of the
clamps. Tighten the clamp’s screw using an electric
screwdriver until the white plastic cap touches the
panel. Do not over tighten the screws to prevent
damaging the Panel PC. The illustration below shows
all clamps properly mounted.
4. Slide the Panel PC through the hole until it is properly
tted against the panel.
5. Position the mounting clamps along the rear edges of
the Panel PC, tting them into the slits that are around
the Panel PC.