34
7. Programme progress display
During programme development, the light
corresponding to the cycle phase which the machine
is in will illuminate. In other words, if the machine is
in the pre-wash or wash phases the light will
come on; if it is in the rinses phase the light will
come on; and finally if it is in the spin phase the light
will come on.
The light FIN will illuminate to indicate that the
selected programme has finished.
The light FIN flashes in the event of operating
problems:
• 4 flashes: door open.
• 2 flashes: problem with water draining.
• 1 flash: problem with water supply.
For more information see paragraph "Something not
working?" at the end of this booklet.
The PUERTA pilot light indicates if the door can be
opened:
- light on: the door cannot be opened
- light off: the door can be opened
- flashing light: the door is opening
It stays on during the whole programme indicating
that the door is locked.
When the light goes out, the door can be opened
(see page 39).
8. Programme selector dial
The selector dial can be turned either clockwise or
counter-clockwise.
Use this selector dial to select the required
programme.
At the end of each programme the selector dial
must be turned to position “O”, to switch off the
machine.
ATTENTION!
If the programme selector dial is turned to another
position (programme) when the machine is working,
the lights of the programme progress display start to
flash. The machine will not perform the new selected
programme, but it will continue running on the same
cycle.
REMEMBER!
In the event a wrong programme has been selected
and the machine is already working, proceed as
follows:
1. Turn the programme selector dial to position “
O”.
2. Select the new required programme.
• If the machine has not already gone through the
rinse cycle, when you decide to change the running
programme, in the new programme the water and
the detergent from the previous cycle will be re-
used, making it an energy-saving tool. On the
other hand, if it is already in the rinse phase;
detergent, bleach,… must be re-measured.
3. Press INICIO / PAUSA button, to start the new
cycle.
