enable “load rom after netboot fails”? y/n [n]:
enable “use all zero broadcast”? y/n [n]:
enable “break/abort has effect”? y/n [n]:
enable “ignore system config info”? y/n [n]:
change console baud rate? y/n [n]: y
enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400 [0]: 0
change the boot characteristics? y/n [n]: y
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2-15 = boot system
[0]: 0
Configuration Summary
enabled are:
diagnostic mode
console baud: 9600
boot: the ROM Monitor
do you wish to change the configuration? y/n [n]:
You must reset or power cycle for new config to take effect
Console Download
You can use console download, which is a ROM monitor function, to download either a software image or a
configuration file over the router console port. After download, the file is either saved to the mini-flash memory
module or to main memory for execution (image files only).
Use console download when you do not have access to a TFTP server.
If you want to download a software image or a configuration file to the router over the console port, you
must use the ROM monitor dnld command.
Note
If you are using a PC to download a Cisco IOS image over the router console port at 115,200 bps, ensure
that the PC serial port is using a 16550 universal asynchronous transmitter/receiver (UART). If the PC
serial port is not using a 16550 UART, we recommend using a speed of 38,400 bps or less when
downloading a Cisco IOS image over the console port.
Note
The following are the syntax and descriptions for the xmodem console download command:
xmodem [-cyrx] destination_file_name
Optional. Performs the download using 16-bit cyclic
redundancy check (CRC-16) error checking to
validate packets. Default is 8-bit CRC.
c
Cisco 800 Series Integrated Services Routers Software Configuration Guide
406 OL-31704-02
ROM Monitor
Console Download
