VIEW Configuration Guide: Cisco WLAN Controllers (Virtual, Modules, and Standalone) with APs
1725-86192-000_AA.docx
August 2013 14
8 Point the TFTP server to the code.
9 Click Download and allow a few minutes for the download to complete.
10 Reboot the Controller.
Controller Setup
The initial setup of the controller is shown below.
Note: Example only
The setup instructions outlined in this document are for the configuration shown in the
diagram only. Your configuration may differ, and the appropriate adjustments must be
made.
Note: The WLC will provision the APs
It is not necessary to configure each AP individually. The WLC is capable of
1 From the main menu, click Controller.
2 Set the AP Multicast Mode to Multicast and enter a multicast IP address that is currently
not being used on your network for the Multicast Group Address.
3 Click the Apply button.
