Chapter 24 Replacing an internal component 203
BCM50 Installation and Maintenance Guide
3 Place the new hard disk in the hard disk bracket.
4 Use the four hard disk bracket screws to secure the hard disk to the bracket.
5 Set the hard disk and bracket in the main unit. See the figure Cable routing on page 204.
Make sure that the hard disk cable and power cable are routed properly. Route the power cable
under the bracket and loop the hard disk cable as shown.
Figure 84 Hard disk and bracket installation
6 Press down lightly on the top of the hard disk to ensure that the hard disk bracket is seated
properly.
Caution: Use only the screws that you removed from the hard disk in the
procedure To remove the hard disk on page 199. Using other screws can damage
the hard disk.
Fan cable cutouts
Fan cable clips
