Toll free: 1-877-536-3976
Local: 1-408-962-0515
atlona.com
4
Baud Rate : 9600 bps, Data Bit :8
bits, Parity : None, Stop Bit :1 bit
•
Code entry is CASE SENSITIVE.
•
Do not insert spaces between letter/
number code entries.
Note1: Feedback for a command
repeats the original command.
Example, if x1$ is a command, the
feedback is the same and if the
command is x2$, the feedback
would also be x2$.
Note2: If command fails, the
feedback should be "Command
FAILED”.
RS-232
1 - Not used
4 - Not used
5 GND Ground
6 - Not used
7 - Not used
8 - Not used
9 - Not used
Command Description Feedback
PWON Power ON PWON
PWOFF Power OFF PWOFF
All#
Reset all input signals to matching output. (Input 1 to Output 1, Input 2 to
Output 2, etc…)
All#
x1$
Switch OFF specificed output channel [1]. If Output channel is 2 the command
would be x2$
x1$
x1AVx2
Switch specified input to output. If input is 5 and output is 3, then command
would be x5AVx3
x1AVx2
x1AVx2,x3,
x4
Switch specified input to mu ple outputs. If input is 5 and outputs are 6, 7, 8,
then the command would be x5AVx6,x7,x8
x1AVx2,x3,x4
Statusx1
Display input currently routed to specified output. Example Statusx1 is asking
what input is currently being routed to Output # 1
x7AVx1
Status Display current rou ng for all inputs and outputs
x2AVx2,
x3AVx4,
Save[Y] Save the current rou ng to a preset command [Y]. [Y] ranges from 0 to 9 Save2
Recall[Y] Recall the preset command [Y]. [Y] ranges from 0 to 9 Recall2
Clear[Y] Clear the preset command [Y]. [Y] ranges from 0 to 9 Clear2
Mreset Reset device to manufacture default Mreset
