9
1.4 Quick Start-Up Procedure
The following abbreviated installation and start-up procedures are provided for
users already familiar with the Journey II Desktop product. If you are not
familiar with this printer, follow all of the instructions in Chapter 1 for setting
up the printer.
1. Unpack the printer using adequate assistance. Save the packing materials.
2. Choose a location for the printer with the following considerations:
• A level surface capable of adequately supporting printer weight.
• Near a grounded power receptacle.
• Adequate clearance: left side — 3 inches (80 mm),
right side — 11 inches (280 mm), top — 15 inches (380 mm),
back — 3 inches (76 mm) if BIN 2 coupons are on the floor (below the
printer) and 9 inches (230 mm) if BIN 2 coupons are on the desktop
(behind the printer).
• Away from excessive illumination; high and low temperature and
humidity; and dirt and dust.
3. Align the front base of the printer with the desktop edge to allow the
OUTPUT BIN DOOR to fully open and hang down out of the way. If the
optional printer stand is used, align the rubber feet on the bottom of the
printer with the holes on the top of the printer stand.
4. Connect and secure the host RS-232 serial connector to the printer’s COM1
serial port located on the back of the printer (the bottom connector).
5. Connect a grounded AC power cord to an AC wall receptacle and the
printer’s AC POWER CORD CONNECTOR located on the back of the
printer.
6. Using one of the keys provided, unlock the BIN 1 ACCESS DOOR located
on the right side of the printer.
7. Open the door completely until it rests on the left top side of the printer.
8. Load ATB ticket stock (maximum of 500 coupons) in the proper
orientation as shown on the BIN 1 instruction label located in the bin.
Gently square the coupon stock against the inside wall of the input bin.
(Coupons must match the document length set in the Profiles.)
9. Insert the staple tab or leading edge of the coupon stock into the BIN 1
INPUT SLOT with the side to be printed facing up.
10. Turn the green STOCK LOAD KNOB A one-quarter ( ¼ ) turn
counter-clockwise (as indicated on the label near the knob).
11. Close and lock the BIN 1 ACCESS DOOR and remove the key.
12. Power the printer on using the POWER SWITCH located on the left side
near the back. Move the switch to the 1 position (towards the front) to turn
on the printer.
13. Wait for the power up self test to complete. The top line of the keypad
display should show ‘On line:’ when complete.
