18
Each filter has the following editable parameters:
Type of Filter
Allows to choose three different types of filter and different attenuation slopes:
Butterworth (But) at 6, 12, 18 or 24dB per octave,
Bessel (Bes) at 12, 18 or 24dB per octave,
Linkwitz-Riley (LR) a 12, 24 or 48dB per octave.
By setting the value, the filter is disabled and the signal passes without its frequency being alThru tered.
Crossover Frequency
Allows to choose the filter cutoff frequency.
OP
1
L
P
F
2k
00 zH
B
es
0
24
OP
1
L
P
F
1k
46 zH
T
hr
0
u
Each Xover has 2 slightly different pages (one for each filter), where the name of the output it affects and the
type of filter are shown.
Low Pass Filter
High Pass Filter
The high-pass filter allows all the frequencies above a specific frequency to pass, whereas it cuts all the frequencies
below it.
LPF HPF
HPFLPF
Signal segment obtained with the combination of LPF and HPF.
Output1-LowPassFilter
PO
1
0
L
P
F
h
r
u
T
1k
00Hz
Output1-HighPassFilter
OP
1
H
P
F
h
r
u
T
1k
00Hz
The low-pass filter allows all the frequencies below a specific frequency to pass, whereas it cuts all the frequencies
above it.
