10. BEFORE FIRST USE
1. Put 2 litre of water in the detergent
compartment for washing phase.
This activates the drain system.
2. Put a small quantity of detergent in
the compartment for washing phase.
3. Set and start a programme for cotton
at the highest temperature without
laundry.
This removes all possible dirt from the
drum and the tub.
11. DAILY USE
WARNING!
Refer to Safety chapters.
11.1 Activating the appliance
1. Open the water tap.
2. Connect the mains plug to the mains
socket.
3. Press button Auto Off to activate the
appliance.
A short tune sounds.
11.2 Loading the laundry
1. Open the appliance door
2. Put the laundry in the drum, one item
at a time.
3. Shake the items before you put them
in the appliance.
Make sure not to put too much laundry
in the drum.
4. Close the door.
CAUTION!
Make sure that no laundry stays between
the seal and the door. There is a risk of
water leakage or damage to the laundry.
11.3 Filling the detergent and
additives
Compartment for prewash phase
an soak programme.
Compartment for washing phase.
Compartment for liquid additives
(fabric conditioner, starch).
Maximum level for quantity of
liquid additives.
Compartment for stain remover.
Flap for powder or liquid
detergent.
Always obey the instructions
that you find on the
packaging of the detergent
products.
11.4 Check the position of the
flap
1. Pull out the detergent dispenser until
it stops.
2. Press the lever down to remove the
dispenser.
www.aeg.com
16
