1. Connect the water inlet hose supplied
with the machine to a tap with a 3/4"
thread. Always use the hose supplied
with the appliance.
2. The machine end of the inlet hose can
be turned in any direction. Set the hose
correctly by loosening the ring nut. Af-
ter positioning the inlet hose, be sure to
tighten the ring nut again to prevent
leaks.
The inlet hose must not be lengthened. If it is
too short and you do not wish to move the
tap, you will have to purchase a new, longer
hose specially designed for this type of use.
Before connecting up the machine to new
pipework or to pipework that has not been used for some time, run off a reasonable
amount of water to flush out any debris that may have collected in the pipes.
Water drainage
The end of the drain hose can be positioned in three ways:
• Hooked over the edge of a sink using the
plastic hose guide supplied with the ma-
chine.
In this case, make sure the end cannot come
unhooked when the machine is emptying.
This could be done by tying it to the tap with
a piece of string or attaching it to the wall.
Installation 27
