Dil ID: 6
Dil Adı: turkish
Dil Kodu: tr2tayfun AEG Markası'nın Ürünleri
Dünyanın En Büyük
Elektronik Bilgi Kütüphanesi



2 flashes: problem with the water draining.
4 flashes: door open.
Once the problem has been eliminated, press the button START to restart the programme. If
after all checks, the problem persists, contact your local Service Centre.
Problem Possible cause/Solution
The machine does not start:
The door has not been closed.
Close the door firmly.
The plug is not properly inserted in the power socket.
Insert the plug into the power socket.
There is no power at the socket.
Please check your domestic electrical installation.
The main fuse has blown.
•Replace the fuse.
The selector dial is not correctly positioned and the button Start
has not been pressed.
Please turn the selector dial and press the button Start again.
The delay start has been selected.
If the laundry are to be washed immediately, cancel the delay
start.
The machine does not fill:
The water tap is closed.
Open the water tap.
The inlet hose is squashed or kinked.
Check the inlet hose connection.
The filter in the inlet hose is blocked.
Clean the water inlet hose filter.
The door is not properly closed.
Close the door firmly.
The machine fills then emp-
ties immediately:
The end of the drain hose is too low.
Refer to relevant paragraph in «Installation» chapter.
The machine does not empty
and/or does not spin:
The drain hose is squashed or kinked.
Check the drain hose connection.
An option or a programme that ends with the water still in the
tub or that eliminates all the spinning phases has been selected.
Select the draining or spinning programme.
The laundry is not evenly distributed in the drum.
Redistribute the laundry.
There is water on the floor:
Too much detergent or unsuitable detergent (creates too much
foam) has been used.
Reduce the detergent quantity or use another one.
Check whether there are any leaks from one of the inlet hose fit-
tings. It is not always easy to see this as the water runs down the
hose; check to see if it is damp.
Check the water inlet hose connection.
The drain or inlet hose is damaged.
Change it with a new one.
What to do if… 21