Operating Instructions
26
The washing cycle is finished/Remove the washing
After a washing program has ended, END (FIM) lights up on the pro-
gram sequence display.
If RINSE HOLD (STOP-ÁGUA NA CUBA) was selected, the display next to
the START/PAUSE (INÍCIO/PAUSA) button flashes.
0 1. After a rinse hold, it is first necessary to pump off the water:
– Either press the START/PAUSE (INÍCIO/PAUSA) button (the water is
pumped off the and the washing is spun according to the finished
program). After the START/PAUSE (INÍCIO/PAUSA) button is pressed
again, the spin speed can still also be changed during spinning), or
– Turn the program selector to OFF (DESLIGAR) and then to PUMP OFF
(ESGOTAR) and press the START/PAUSE (INÍCIO/PAUSA) button (the
water is pumped off without spinning),
or
– Turn the program selector to OFF (DESLIGAR) and then to SPIN (CEN-
TRIFUGAR) or SHORT SPIN (CENTRIFUGAÇÃO SUAVE) and press the
START/PAUSE (INÍCIO/PAUSA) button (the water is pumped off and
the washing is spun or gently spun).
After the end of this program step, the END (FIM) indicator will illumi-
nate.
2. Open the filling door.
As soon as the DOOR (PORTA) indicator lights up green, the filling door
can be opened.
3. Remove the washing.
4. Turn the program selector to OFF (DESLIGAR).
5. Close the water valve.
6. After washing, pull out the washing detergent drawer slightly so that it
can dry out. Only lean the door against the washing machine so that
the latter can air out.
3
If the display OVER DOSING (EXCESSO DETERGENTE)
lights up, too much washing detergent was used in the
washing program just ended. During the next wash,
pay attention to the dosing information of the washing
detergent manufacturer and pay attention to the filling quantity!
Important! If the washing machine is not used for a long time:
Close the water tap and disconnect the washing machine from the
electricity mains.
