21
Washing machine vi-
brates when operating
or is noisy.
Transit packaging has not
been removed.
Remove transit packaging.
Screw feet not correctly ad-
justed.
Adjust feet according to the
Installation and Connection
instructions.
There is very little washing
in the drum (e.g., just one
bathrobe).
This does not affect how the
machine operates.
Water is leaking out un-
derneath the washing
machine.
Screw connection on the in-
let hose is leaking.
Tighten inlet hose.
Drain hose is leaking. Replace drain hose.
Drain pump cover is not
closed properly.
Close cover properly.
Washing was caught in the
door.
Load washing carefully for
the next wash.
Emergency drain hose is
leaking.
Close off emergency drain
hose properly.
EF0 appears. END indi-
cator flashes 15x, at the
same time an acoustic
signal sounds 15x.
The drain pump runs
constantly, even when
the machine is switched
off.
The Aqua Control anti-flood
system has responded.
Turn off the tap, remove the
mains plug from the socket
and contact the Customer
Care Department.
Washing water is foam-
ing excessively. At the
end of the washing cy-
cle, the spin stops. OVER
DOSING indicator is lit.
Probably too much deter-
gent has been used.
Dose detergent exactly as in-
structed by manufacturer.
E20 appears.
END indicator flashes
2x, at the same time an
acoustic signal sounds
2x.
(Problems with water
outflow.)
Kink in the drain hose. Remove kink.
Maximum pumping height
of 1m exceeded.
Please contact the Customer
Care Department.
Drain pump is blocked.
Switch off appliance. Pull out
mains plug.
Clean drain pump. Remove
foreign bodies from pump
housing.
With connection to sink
outlet: sink outlet is
blocked.
Clean out sink outlet.
Problem Possible cause Remedy
