16
Starting a programme
1. Check that the tap is turned on.
2. Press the START/PAUSE button. The programme is started or starts after
the time delay set has elapsed.
3 If after the START/PAUSE button has been pressed E40 flashes in the
multi-display, the END indicator flashes 4 times and at the same time
an acoustic signal sounds 4 times, the door is not closed properly. Push
the door firmly closed and press the START/PAUSE button again.
Programme progress
• The programme progress display shows the programme step that is
currently being performed.
• The multi-display indicates the estimated time remaining (in minutes)
until the end of the programme.
3 During the washing cycle the remaining time may be increased or stay
the same for a while as the programme adjusts itself to different condi-
tions (e. g. type and quantity of laundry, out of balance spin detection,
special rinses, etc.).
Interrupting a programme/adding washing
Interrupting a programme
• A washing programme can be interrupted at any time by pressing the
START/PAUSE button. It is then re-started by pressing the START/
PAUSE button again.
• To stop the washing machine before the programme has ended, turn
the programme knob to OFF. Important! Be careful if there is water
in the appliance!
Adding washing
It is possible to add washing, as long as the DOOR light is lit green.
1. Press the START/PAUSE button. The door can be opened.
2. Shut the door and press the START/PAUSE button again. The pro-
gramme continues.
