6766
Something not working?
If during the spin cycle the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a new type of
motor.
If water is not visible in the drum, this is due
to the modern technology of new washing
machines that use less water than traditional
machines.
Troubleshooting
If a problem arises, you can try to solve it yourself following the
instructions below.
If you call out an engineer when one of the following problems arises,
or to repair a fault due to incorrect use, the call-out will be charged
even if requested within the guarantee period.
During machine operation the following lights may flash:
-PROGRAM SONU + SUDA BEKLETME: problem with the water supply
-PROGRAM SONU + DURULAMA: problem with water draining
-PROGRAM SONU + ANA YIKAMA: door open
Once the problem has been eliminated, press the START/PAUSE button
to restart the programme. If after all checks, the problem persists, con-
tact your local AEG Service Force Centre.
Problem
The machine does not work
Possible cause
The main electrical fuse Replace the fuse.
has blown.
The door is not properly Close the door; the click
closed. of the lock should be heard.
The plug is not connected. Insert the plug.
The ON/OFF button has not Press the button.
been pressed.
The START button has not Press the button.
been pressed.
The DELAY START Check the selected delay on
option has been selected. the display.
Solution
Problem
The machine does not
empty and/or does not spin
Possible cause
The drain hose is Check the whole length of
squashed or kinked. the hose and remove the
kink.
The drain filter or the Clean the filter or check
drain hose are clogged. the hose.
The ANTI-CREASE option Empty out the water by
(stop with water in drum) pressing the START button
has been selected. or selecting the DRAIN
programme.
The laundry is not evenly Redistribute the laundry
distributed inside the drum. manually in the drum.
There is water on the floor
Too much detergent has Measure detergent
been used. according to the
manufacturer’s instructions.
An unsuitable detergent Use a suitable washing
has been used that machine detergent.
creates too much foam.
One of the connectors on Check that the hose is
the water inlet hose is firmly screwed on at both
leaking. ends.
The drain filter has not Fully screw the filter into
been properly screwed on place.
after cleaning.
Solution
The machine does not fill
The water tap is closed. Open the water tap.
The water inlet hose is Check the whole length of the
squashed or kinked. hose and remove the kink.
The small filter of the water Clean the filter.
inlet hose is clogged.
The door is not properly Close the door.
closed.
The machine fills then
empties immediately
The end of the drain hose Place the hose at the right
is too low. height (see Installation
section).
