Instructions for use
35
Washing heavily
creased
Too mush washing probably
put in.
Pay attention to the maxi-
mum filling quantity (see
Program tables). For easy-
care textiles, select the pro-
gram EASY IRON (STRIJKVRIJ,
SANS REPASSAGE).
Washing not well spun.
Residual water still vis-
ible in the drum.
Fault code
(2
appears.
Drainage hose bent. Remove the bend.
Maximum pump head (outlet
head 1m from unit's floor
surface) exceeded.
Consult Customer Service.
They can supply a retrofit kit
as a special accessory for
delivery heads of more than
1m.
Solution pump blocked.
Switch off the unit and pull
out the mains plug. Clean
the solution pump.
If a siphon is connected:
Siphon blocked.
Clean the siphon.
The filling door cannot
be opened with the
unit switched on.
Door locked for safety rea-
sons (display DOOR/LIGHT,
DEUR/LICHT, PORTE/ ECLAIR.
is off).
Wait until the display DOOR/
LIGHT (DEUR/LICHT, PORTE/
ECLAIR.) lights up green.
The program saving function
is set.
Cancel the program saving
function (see section ”Pro-
gram saving”).
Washing detergent res-
idues form in the
washing detergent
drawer.
Water valve not fully opened. Open the water valve fully.
Filter in the screw connec-
tion of the intake hose on
the water valve or on the
unit is blocked.
Close the water valve.
Unscrew the intake hose
from the water valve and
from the unit and clean the
filter.
The rinsing water is
murky.
The cause is probably a
detergent with a high silicate
content.
No negative influence on the
rinsing result, possibly use
liquid detergent if necessary.
Problem Possible Cause Remedy
