Operating Instructions
24
Washing cycle is complete/Removing Washing
A wash programme normally ends with the final spin.
If SOAKING has been selected:
0 Release the SOAKING button (main wash for COTTONS/LINEN or EASY-
CARES will run).
If RINSE HOLD has been selected:
The water must first be pumped out or the washing must still be spun.
0 Either release the RINSE HOLD button
(water is pumped out and the washing spun according to the pro-
gramme that has been run; the spin speed can still be changed even
during the spin),
or
turn the programme selector clockwise to PUMP OUT
(water will be pumped out without spinning),
or
turn the programme selector clockwise to SPIN
(water will be pumped out and the washing spun at the set speed; the
spin speed can still be changed even during the spin).
Once the programme is completed:
3
For safety reasons, the door remains locked for 1-2 minutes after the
end of the programme.
0 1. Open the door.
2. Remove the washing.
3. Press ON/OFF button. The power indicator light will go out.
The washing machine has been switched off.
4. Turn off the water tap.
5. Pull the washing detergent disperser drawer out slightly to allow it to
dry. Leave the door ajar so that air can circulate in the drum.
Important! If the washing machine is not to be used for a long period:
Close the water tap and disconnect the washing machine from the
electricity mains.
