31
Emergency emptying out
If the water is not discharged (pump is blocked, filter or drain hose are
clogged), proceed as follows to empty out the machine:
• pull out the plug from the power socket;
• close the water taps;
• if necessary, wait until the water has cooled;
• place a bowl on the floor;
• put the drain hose end into the bowl and let the water out.
Should it not be possible to have access to the drain hose because, for
example the appliance is built in the kitchen furniture, slightly loosen
the drain filter after placing a bowl on the floor to let the water come
out slowly.
At the end screw the filter again.
Frost precautions
If the machine is installed in a place where the temperature could drop
below 0°C, proceed as follows:
• Close the water taps and unscrew the water inlet hoses from the taps.
• Place the end of the drain hose and the inlet hoses in a bowl placed
on the floor.
• Select the “PUMP OUT” programme and run it until the machine
stops.
• Press the ON/OFF button to switch the machine off.
• Remove the plug from the power socket.
• Screw the water inlet hoses back on and put the drain hose back in
its place.
By doing this, any water remaining in the machine is removed, avoiding
the formation of ice and, consequently, damage to the appliance.
When you use the machine again, make sure that the ambient temper-
ature is above 0°C.
30
Something not working?
If, during the spin cycle, the machine makes an unusual
whistling noise, different from the noise made by tradi-
tional washing machines, this is due to a new type of
motor.
If water is not visible in the drum, this is due to
the modern technology of new washing
machines that use less water than traditional
machines.
Troubleshooting
If a problem arises, you can try to solve it yourself following the
instructions below.
If you call out an engineer when one of the following problems arises,
or to repair a fault due to incorrect use, the call-out will be charged
even if requested within the guarantee period.
If after all checks, the problem persists, contact your local AEGService
Force Centre.
Problem
The machine does not work
Possible cause
The ON/OFF button Depress the button.
has not been depressed.
The main electrical fuse or Replace the fuse.
the fuse in the plug has
blown.
The door is not properly Close the door; the click
closed. of the lock should be heard.
The plug is not connected. Insert the plug.
The programme selector Turn the dial to the correct
dial is not correctly position.
positioned.
Solution
Cleaning and maintenance
