• Items that have been soiled with
substances such as vegetable or
mineral oil, acetone, alcohol, petrol,
kerosene, spot removers, turpentine,
waxes and wax removers should be
washed separately with an extra
amount of detergent before being
dried in the washer dryer.
• Do not use the appliance if items
have been soiled with industrial
chemicals.
• Do not dry unwashed items in the
wash dryer.
• Items such as foam rubber (latex
foam), shower caps, waterproof
textiles, and rubber backed articles
and clothes, or pillows fitted with
foam rubber pads should not be dried
in the washer dryer.
• Fabric softeners, or similar products,
should only be used as specified by
the product manufacturer’s
instructions.
• Remove all objects from items that
could be a source of fire ignition such
as lighters or matches.
• Never stop the washer dryer before
the end of the drying cycle unless all
items are quickly removed and
separated so that residual heat can
dissipate.
• The final part of the washer dryer
cycle takes place without heat (cool
down cycle) to ensure that items
reach a temperature that will not
cause damage to them.
• Do not use high pressure water sprays
and/or steam to clean the appliance.
• Clean the appliance with a moist
cloth. Use only neutral detergents. Do
not use abrasive products, abrasive
cleaning pads, solvents or metal
objects.
• Before any maintenance operation,
deactivate the appliance and
disconnect the mains plug from the
socket.
2. CONDITIONS OF USE
This appliance is intended to be used in
household and similar applications such
as:
• Farm houses
• By clients in serviced apartments,
holiday apartments and other
residential type environments.
3. SAFETY INSTRUCTIONS
3.1 Installation
The installation must comply
with relevant national
regulations.
• Follow the installation instructions
supplied with the appliance.
• Do not install or use the appliance
where the temperature can be less
than 5°C or higher than 35 °C.
• Always keep the appliance vertical
when being moved.
• To make sure the compressor works
properly, wait 6 hours after the
installation before using the
appliance.
• Make sure that there is air circulation
between the appliance and the floor.
• Remove all the packaging and the
transit bolts.
• The floor area on which the appliance
is to be installed must be flat, stable,
heat resistant and clean.
• Keep the transit bolts in a safe place.
If the appliance is to be moved in the
future they must be reattached to lock
the drum to prevent an internal
damage.
• Always take care when moving the
appliance as it is heavy. Always use
safety gloves and enclosed footwear.
• Do not install or use a damaged
appliance.
• Do not install the appliance where the
appliance door cannot be fully
opened.
www.aeg.com
4
