Programmes Load
(Kg)
Energy con-
sumption
(kWh)
Water con-
sumption (li-
tre)
Approxi-
mate pro-
gramme
duration
(minutes)
Remaining
moisture
(%)
1)
Standard 40
°C cotton
3.5 0.52 41 210 52
1)
At the end of spin phase.
Off Mode (W) Left On Mode (W)
0.48 0.48
The information given in the chart above are in compliance with the EU Com-
mission regulation 1015/2010 implementing directive 2009/125/EC.
7. OPTIONS
7.1 Temperature (Temp.)
Set this option to change the default
temperature.
Indicator
= cold water.
The indicator of the set temperature
comes on.
7.2 Spin (U./Min.)
With this option you can decrease the
default spin speed.
The display shows the indicator of the
set speed.
Additional spin options:
No Spin
• Set this option to remove all spin pha-
ses.
• Set it for very delicate fabrics.
• The rinse phase uses more water for
some washing programmes.
•
The display shows the indicator
.
Rinse Hold
• Set this option to prevent the laundry
creases.
• The washing programme stops with
the water in the drum. The drum turns
regularly to prevent the laundry crea-
ses.
• The door stays locked. You must drain
the water to unlock the door.
•
The display shows the indicator
.
To drain the water refer to ‘At
the end of the programme’.
7.3 Stain (Flecken)
Set this option to add the stain phase to
a programme.
Use this option for laundry with hard
stains to remove.
When you set this option, put the stain
remover into compartment
.
This option increases the pro-
gramme duration.
This option is not available with a
temperature lower than 40 °C.
7.4 Extra Rinse (Extra Spülen)
With this option you can add some rin-
ses to a washing programme.
Use this option for persons allergic to
detergents and in areas where the water
is soft.
The related indicator comes on.
7.5 Time save (Zeit Sparen)
With this option you can decrease the
programme duration.
ENGLISH 11
