Programmes Load
(Kg)
Energy con-
sumption
(kWh)
Water con-
sumption (li-
tre)
Approxi-
mate pro-
gramme
duration
(minutes)
Remaining
moisture
(%)
1)
Standard 60
°C cotton
7 0.86 52 240 52
Standard 60
°C cotton
3.5 0.74 41 215 52
Standard 40
°C cotton
3.5 0.52 41 210 52
Off Mode (W) Left On Mode (W)
0.48 0.48
The information given in the chart above are in compliance with the EU Com-
mission regulation 1015/2010 implementing directive 2009/125/EC.
1)
At the end of spin phase.
7. OPTIONS
7.1 Temperature (Temp. °C)
Set this option to change the default
temperature.
Indicator
= cold water.
The indicator of the set temperature
comes on.
7.2 Spin (T/min.)
With this option you can decrease the
default spin speed.
The display shows the indicator of the
set speed.
Additional spin options:
No Spin
• Set this option to remove all spin pha-
ses.
• Set it for very delicate fabrics.
• The rinse phase uses more water for
some washing programmes.
•
The display shows the indicator
.
Rinse Hold
• Set this option to prevent the laundry
creases.
• The washing programme stops with
the water in the drum. The drum turns
regularly to prevent the laundry crea-
ses.
• The door stays locked. You must drain
the water to unlock the door.
•
The display shows the indicator
.
To drain the water refer to ‘At
the end of the programme’.
7.3 Stain (Vlekken - Taches)
Set this option to add the stain phase to
a programme.
Use this option for laundry with hard
stains to remove.
When you set this option, put the stain
remover into compartment
.
This option increases the pro-
gramme duration.
This option is not available with a
temperature lower than 40 °C.
7.4 Extra Rinse (Extra Spoelen
- Rinçage+)
With this option you can add some rin-
ses to a washing programme.
ENGLISH 11
