8. OPTIONS
8.1 Programme knob
Turn this knob to set a programme. The
related programme indicator comes on.
8.2 Start/Pause
Press button Start/Pause to start or
interrupt a programme.
8.3 Delay Start
With this option you can delay the start
of a programme from 30 minutes to 20
hours.
The display shows the related indicator
and delay time.
8.4 Time Save
With this option you can decrease the
programme duration.
• Press this button one time to set
'Shortened duration' for items with
daily soil.
• Press this button two times to set
'Extra Quick' for slightly soiled items
only.
Some programmes accept
only one of the two options.
8.5 Extra Rinse
With this option you can add some rinses
to some washing programmes, refer to
"Programme chart".
Use this option for persons allergic to
detergents and in areas where the water
is soft.
The related indicator comes on.
8.6 Stains
Set this option to add the stain phase to
a programme.
Use this option for laundry with hard
stains to remove.
When you set this option, put the stain
remover into compartment .
This option increases the
programme duration.
This option is not available
with a temperature lower
than 40 °C.
8.7 Spin
With this option you can decrease the
default spin speed.
The display shows the indicator of the set
speed.
Additional spin options:
No Spin
• Set this option to remove all spin
phases.
• Set it for very delicate fabrics.
• To compensate for the absence of
spinning, the rinse phase uses more
water for some washing programmes.
• The display shows the indicator
.
Rinse Hold
• Set this option to reduce creasing.
• The washing programme ends with
water in the drum. The drum turns
regularly to reduce creasing.
• The door stays locked. You must drain
the water to unlock the door.
• The display shows the indicator
.
To drain the water refer to
"Draining water out after
end of cycle".
8.8 Temp.
Set this option to change the default
temperature.
Indicator = cold water.
The display shows the set temperature.
www.aeg.com
14
