27What to do if…
Malfunction Possible cause Remedy
1 short warning tone, con
tinuously repeated, can be
heard,
the cycle indicator for the se
lected wash program is flash
ing:
the control indicator
lights up:
fault code
Å10 is displayed
in the multidisplay:
(Problems with water inlet)
Water tap is blocked with
limescale or is faulty.
Check the tap and have it re
paired, if necessary.
The tap is turned off. Turn on the tap.
The filter (where present) in the
threaded hose fitting on the
tap is blocked.
Clean the filter in the threaded
hose fitting.
Filters in the base of the wash
ing compartment are blocked.
Cancel the dishwashing cycle
(see chapter: Starting a dish
washing cycle),
clean filters (see chapter:
Cleaning the filters),
then start the dishwashing cy
cle again.
Water supply hose has not
been correctly positioned.
Check the position of the hose.
2 short warning tones, con
tinuously repeated, can be
heard,
the cycle indicator for the se
lected dishwashing cycle is
flashing,
fault code
Å20 is displayed
in the multidisplay. (Prob
lems with water outflow)
The sink outlet is blocked. Clean the siphon.
Water drain hose has not been
correctly positioned.
Check the position of the hose.
3 short warning tones, con
tinuously repeated, can be
heard,
Fault code
Å30 is displayed
in the multidisplay.
The antiflood system has been
triggered.
First shut off the water tap,
then switch off the appliance
and contact the Customer Care
Department.
The cycle is not starting.
The mains plug is not plugged
in.
Connect the plug to a mains
socket.
A fuse in the house’s wiring
system is defective.
Replace fuse.
For dishwasher models with a
delay start timer:
A start time has been selected.
If the dishes are to be washed
immediately, cancel the delay
start.
