internal components the dishwasher has to be unplugged.
When inserting the machine, ensure that the water inlet hose, the drain hose and the supply
cable are not kinked or squashed.
Adjusting the height of the dishwasher
To adjust the height proceed as follows:
1. Loosen or tighten the two front feet.
2. Loosen and remove the adjustable plinth.
3. Adjust the rear foot by turning the screw in the middle of the front kick plate to the
left or to the right. Good levelling is essential for correct closure and sealing of the
door.
When the appliance is correctly levelled, the door will not catch on the levelling spacers on
either side of the cabinet. If the door does not close properly, loosen or tighten the ad-
justable feet until the machine is perfectly level.
Adjusting the height of the plinth
It is important for the dishwasher to be abso-
lutely horizontal so that the door seals properly.
The adjustable feet are to be turned to the left
or right until the dishwasher is horizontal. If
there is a space at the bottom of the machine,
this can be covered by lowering the plinth.
Adhesive steam protection foil
Fit the steam protection onto the front part of the
worktop along the entire width.
600 mm
26
Installation
