Analog Connections - Outputs
Configuration Active Balanced
Impedance 310 Ω
Clipping Level
(minimum)
Line: +26.2 dBV
Aux: +16.2 dBV
Mic: −3.8 dBV
Analog Connections - Input(s)
Configuration Active Balanced
Impedance 10.6 kΩ
Clipping Level
(minimum)
Line: +23.8 dBV
Aux: +10.8 dBV
Headphone Output 6.35 mm (1/4") TRS, 100 mW, 350 Ω, dual mono (will drive stereo phones)
0 dBV=1 V RMS 0 dBu=0.775 V RMS 0 dBV=2.2 dBu
Digital Signal Processing
AD/DA Converter 24-bit, 48 kHz
Latency
(Estimated Nominal, ±0.1 ms)
Analog-to-Dante: 0.21 ms
Dante-to-Analog: 0.24 ms + TN
TN = Network latency in milliseconds, as set in Dante Controller.
Note: Dante network latency is typically associated with the receiving device.
Networking
Network Interface Four-Port Gigabit Ethernet Switch, Dante digital audio
Uplink Port (Port 4) Selectable, blocks multicast traffic
Power over Ethernet (PoE) Provided on Port 1 to power MXWAPT
Cable Requirements Cat 5e or higher, shielded, 100 m maximum between network devices
Network Addressing Capability DHCP, link-local, static
Specifications (subject to change)
Audio Frequency Response 20 Hz to 20 kHz (+1, −1.5 dB)
Dynamic Range
(20 Hz to 20 kHz, A-weighted, typical)
Analog-to-Dante: 113 dB
Dante-to-Analog: 110 dB
Output Noise
(20 Hz to 20 kHz, A-Weighted, typical)
Line: −84.5 dBV
Aux: −95.2 dBV
Mic: −106.5 dBV
THD+N
(20 Hz to 20 kHz@ +4dBu analog input,
−10 dBFS digital input)
<0.05%
Polarity Non-inverting, any input to any output
Dimensions 44 mm x 483 mm x 366 mm (1.7 in. x 19.0 in. x 14.4 in.), H x W x D
Weight MXWANI4 3.1 kg (6.9 lbs)
MXWANI8 3.2 kg (7.1 lbs)
Housing Steel; Extruded aluminum
Power Requirements 100 to 240 V AC, 50–60 Hz, 1 A
Operating Temperature Range −18°C (0°F) to 63°C (145°F)
Storage Temperature Range −29°C (-20°F) to 74°C (165°F)
Optional Accessories
90A20082 Hardware Kit
95B8389 IEC Cable
Available Models
MXWANI8 8-Channel Audio Network Interface
MXWANI4 4-Channel Audio Network Interface
www.shure.com
