12
Stage v166: Handheld Wireless System
Issue Solutions
No Audio
Turn on the HT6 transmitter using the Power ON/OFF switch.
Ensure the HT6 transmitter’s batteries are installed correctly.
Check that the HT6 Audio ON/OFF switch is in the ON position.
Conrm that the SR166 adaptor is correctly connected and
plugged into an electrical outlet.
Turn on the SR166 receiver.
Make sure the SR166 output and audio input connections are
securely connected.
Ensure that the SR166 receiver and HT6 transmitters are in line of
sight with one another.
Check the receiver and audio input device level controls.
Distorted Audio
Check the receiver output level and audio input device level.
Check the HT6’s batteries and replace if low.
Another transmitter may be broadcasting on the same channel.
Turn o transmitter that may be causing interference.
Audio Dropout
The transmitter may be too far away from the receiver. Move
closer to the receiver, or reposition the antennas.
Remove any sources that may cause RF interference, such as cell
phones, cordless phones, lighting equipment, computers, etc.
Transmitters and Receiver
on Dierent Channels
Contact your Samson reseller or distributor for assistance.
Troubleshooting
