ENGINE – CAMSHAFT, VALVE STEM SEAL
11-10
B
Fitting the valve spring
Fit the valve spring so that the end of the valve spring which has
the smaller radius is on the rocker arm side.
C
Fitting the valve spring retainer lock
In the same way as when the valve spring retainer lock was
removed, compress the valve spring using the special tool for
compressing valve springs (MD998772), and fit the valve spring
retainer lock.
D
Fitting the rush adjuster
Caution
If a rush adjuster is being reused, it must be washed and
inspected before fitting.
(Ref: Engine Service Manual)
E
Fitting the camshaft
1. Remove any sealant from the cylinder head.
2. Apply engine oil to the camshaft cams and journals.
3. Fit the camshaft to the cylinder head.
Caution
Ensure that the inlet and exhaust sides are not the wrong way
round.
F
Fitting the camshaft bearing cap No.4, the camshaft
bearing cap No.3, the camshaft bearing cap No.5, the
camshaft bearing cap No.2, the rear camshaft bearing
cap, and the front camshaft bearing cap
1. Set the camshaft dowel pins in the position shown in the
diagram.
Rocker arm side
Front of engine
<inlet side>
<exhaust side>
slit
slit
Approx. 4°
dowel pins
inlet side
exhaust side
