HOW TO LtVil YOUR
REFRIGERATOR
II your refrigerator requires an ice mater
water supply connection, refer to How
to Connect the Water Supply
(page
10) before leveling your refrigerator
A CAUTION
To protect personal property or
refrigerator from damage, observe
the following:
> Protect soft vinyl or other flooring
with cardboard, rugs, or other
protective material.
DO NOT use power tools when
performing leveling procedure.
MATERIALS NEEDED
>■ %" hex head driver
>■ Level
1, Remove toe grille and bottom bracket
covers (see previous instructions),
2 Turn both front adjustment screws (A)
clockwise to raise and counter
clockwise to lower
3. Turn both rear adjustment screws
clockwise to raise and
counterclockwise to iower.
B)
4, Using a level, make sure front of
refrigerator is '// (6 mm) or % bubble
higher than back of refrigerator. See
leveling step 3 for assistance.
if required, correct rocking of
refrigerator by turning rear
adjustment screw clockwise to raise
rocking corner If doors are
uneven,..
Determine which door needs to be
raised,
>• Turn front roller adjustment screw
clockwise to raise front corner of
door.
m
o
bÔ
X
>■ if the refrigerator has reached the
Umit of its adjuslment range, and
doors are still not level-lower
opposite door by turning roller
adjustment screw
counterclockwise,
>- Check with level to verify 'ff till to
the back for proper door closure
> if refrigerator is aligned and stable,
replace toe grille and hinge
covers
11
