15
Chapter II: System and Network Setup
2-1 Build Network Connection
Please follow the following instructions to build the network connection
between your new HAWNR3 router and your computers and other network
devices:
1. Connect your xDSL /cable modem to the WAN port of this router by
Ethernet cable.
2. Connect all your computers and network devices (network-enabled
consumer devices other than computers, like game console, or switch /
hub) to the LAN port of the router.
3. Connect the A/C power adapter to the wall socket, and then connect it to
the ‘Power’ socket of the router.
4. Please check all LEDs on the front panel. ‘PWR’ LED should be steadily
on, WAN and LAN LEDs should be on if the computer / network device
connected to the respective port of the router is powered on and correctly
connected. If PWR LED is not on, or any LED you expected is not on,
please recheck the cabling, or jump to ‘5-2 Troubleshooting’ for possible
reasons and solutions.
