Software Operation Manual 22
manage the Server. The Server supports all relevant parts of MIB-II and a private MIB. You can set
these MIB variables from the Server’s web pages or by using the Control Center. You can set
community and some parameters for SNMP server. The SNMP Configuration includes:
Authentic Community: set Community name of SNMP server.
Trap Community: set Trap Community name for SNMP server to send trap packets.
Trap Address (IP): enter an IP address to send the Trap packet.
SysContact: enter some letters for variable of SysContact that represents the name of system
contact.
SysName: enter some letters for variable of SysName that represents the name of system.
SysLocation: enter some letters for variable of SysLocation that represents the location of system.
EnableAuthenTrap: enter 1 or 2 for the variable of EnableAuthenTrap that represents to enable (1)
or disable (2) to send Trap packets receiving the wrong Community name.
SMTP:
SMTP Protocol: enable or disable the SMTP Protocol.
SMTP Server Name: set the IP address or server name of SMTP Server.
SMTP Port Number: set the port number, the range is from 1 to 65535. Typical is 25.
Subject: set the subject of notification mail.
From Address: set the From Address of notification mail.
To Address: set the From Address of notification mail.
Cc: set the Cc receiver of notification mail.
Duration Cycle: set the cycle time to send the notification mail.
Event Counter: set the accumulation number of error messages to send the notification mail.
＊Note: If Duration Cycle and Event Counter are both set together, the sending notification mail
event will be triggered depending on which conditions is fulfilled first.
