28
DT2 / DT4 series User Manual
10. Open the dispenser by
folding it out.
11. Load the labels,
following the instructions
in Section 2-1.
12. Remove the first label
and
pass the label liner over
the roller and the
tear-off plate.
【
Note
】
The label stock should be at
least 25 mm high.
【
Suggestion
】
When using the label
dispenser, set the stop
position to 9 mm (DT2: 8 mm).
through the printer and
dispenser as shown in
the illustration.
14. Fold up the dispenser
cover to close it.
15. Switch on the printer
and press the FEED
button to measure the
label stock.
