Wireless LAN WDS Facility
Vigor 2850 'n' models support WDS (Wireless Distribution System) which enables you to use the wireless capability to bridge to another
network, within wireless range. You need an additional compatible wireless router for this of course. Here is a simple example:
With WDS bridging, both networks should be within the same logical IP subnet (IP address range). Once set up, all of the PCs on both
sides of the link can access each other, across the wireless bridge. Local wireless devices such as a laptop can continue to use their local
access point.
An additional mode, as shown above, called 'repeating', allows you to set up a third station. In the diagram below, the router at 'B' is set
up in repeating mode, relaying traffic between LANs at A and C. Therefore, all three physical networks can communicate with each other
over the wireless links.
Important Note : Wireless performance (speed and range) always depends on your specific environment and will vary
considerably. Factors affecting performance include wireless traffic, other networks nearby, site construction, walls, ceilings and
other electronic equipment nearby. The product may not be upgradable to future 802.11n standards or be compatible with
products from other manufacturers. Speeds quoted are the maximum wireless capacity, including RX/TX capacity, protocol
overheads and all clients/hosts connected.
